Page History

All JS-25 models have only two connectors: an Ethernet connector and a circular connector for power and control signals (shown in Figure 1 below).

...

Ethernet Connector
The Ethernet connector is the industrial version of a simple RJ45 jack. It is sealed, but otherwise identical to standard networking connectors. In a development setting, it is acceptable to use regular Ethernet patch cables to connect scanners to a switch. For the intended application in a production environment, JoeScan highly recommends the use of the cables supplied by JoeScanus. These cables are manufactured to a higher standard and contain additional shielding to function in noisy electrical environments.

Power/Control Signal Connector
The other connector, an iConn Systems waterproof 8-pin circular connector, carries power and control signals (Encoder and StartScan). The pin-out of the connector is listed in Table 1.

Table 1. iConn Systems Waterproof Connector pin-out. 

 


The corresponding cable is called the Control Cable. JoeScan sells this cable in different lengths, with an iCONN Systems waterproof 8-pin connector on one end and pigtails (bare wire ends) on the other.

...

• Link light: Once the scan head is connected to an Ethernet switch and ( and has power), the Link light will turn green.
• Activity light: Flickers amber if there is traffic on your network. This means that at the physical layer, the scanner is connected and ready to go (at the the physical layer).
• Status light: Only used internally

...